My Rear Fender Chaps, also commonly referred to as Rear Fender Bras, are available for all years and models of Harley Davidson Freewheelers, RG3, SG3 and TriGlide bikes.

​

                No drilling holes in your Fenders, or disassembly of the bike is necessary.

​

The Fender design changed with the 2026 RG3 and SG3, so please always state what year and model of bike you are ordering for.

​

Your Rear Fender Chaps/Rear Fender Bras are crafted from very high-quality leather.

I use leather because it allows the Fender Chaps/Fender Bras to breathe, without trapping moisture underneath.  The leather used is thin enough to stretch but thick enough to protect the face of the Fender from just about anything it might get hit by out on the road. Kicks from passenger boots, rocks thrown by vehicles and just about anything you’re ever going to encounter, will bounce right off the Fender Chaps/Fender Bras, without even causing so much as a scratch. Vinyl Bras heat up, stretch in the warm sun and then start flapping and ruining paint. That won’t happen with my all leather Fender Chaps/Fender Bras. The leather Fender Chaps/Fender Bras will be stretched tightly over the Fender.  The attachment system is made by Velcro USA and is the most High-Tech Hook and Loop System you can buy from Velcro USA.  It is a "Special Order" item that is used primarily in The Aerospace Industry.  The Adhesive Backed Polyester Hook Strip is 100% Waterproof, won’t creep or shrink and its’ operating temperature is minus 45 degrees (-45) to plus 185 degrees (+185) Fahrenheit. Opening and closing strength is rated at 500 openings by Velcro USA.  Best of all, it will not harm OEM Factory Paint, no matter how long it is in place.

After the initial installation, the Fender Chaps/Fender Bras can be quickly removed (takes about one minute). Putting them back on is just about as easy as removing them and takes less about five minutes.  Adjustments/tightening, if ever needed, can be made to both sides in less than one minute.

​

Rear Fender Chaps/Rear Fender Bras can be ordered in size Medium, Large and Extra Large and can be ordered for all model years of the Freewheeler, RG3, SG3 and TriGlide. 

 ​

The size Medium covers approximately 14-inches of the lower face of the Fender and is priced at $200.00 per set. ​

 

The size Large covers approximately 21-inches of the lower face of the Fender and is priced at $225.00 per set. ​

 

The size Extra Large covers approximately 28-inches of the lower face of the Fender and is priced at $250.00 per set.